Barco FS35 Instrukcja Użytkownika Pobierz pdf (Strona 5)

Communication protocoll Rev. 1.18

Communication Protocol

This section describes how to use the communication protocol to control projectors remotely.

When the projects are connected to either RS232 or LAN you can control the projectors through this ASCII based protocol.

Note: Some commands will generate OSD feedback. This can be turned off from the projector’s menu system or by setting

“OSDC” to value 0 (OSD off) or value 1 (OSD show only warnings).

Timing

General timing constraints:

• Wait 30 seconds after power on before sending next command.

• Wait for response before sending next command.

• Minimum 2 seconds delay before resending if no response received.

• Minimum 500ms delay between commands.

• Minimum 5 seconds delay after sending 20 commands

Overview

The protocol has the following deﬁnition:

HEADER SEPARATOR ADDRESS SEPARATOR MESSAGE BODY TERMINATOR

1 byte 1 byte 1 -3 bytes 1 byte N bytes 1 byte

Field Description Comment

Header ASCII character ‘:’ Required

Separator ASCII character ‘space’ Optional

Address 1 – 3 bytes address Optional

Terminator CR carriage return (0x0D) Required

Message body

The message body structure is as follows:

MNEMONIC SEPARATOR] MODIFIER SEPARATOR VALUES SEPARATOR TARGET

1 byte 1 byte 1 -3 bytes 1 byte N bytes 1 byte N bytes

Field Description Comment

Mnemonic 4 bytes key identiﬁer, not case sensitive Required

Modifer Single char symbol Optional

Values N bytes value (max 6 bytes) Optional

Target N bytes value (max 4 bytes) Optional

Separator ASCII character ‘space’ Optional

Mnemonic

The Mnemonic is 4 bytes key identiﬁer, know as the ASCII command.

Example: POWR, SABS, IDVI

Modiﬁers

R Relative change. Value given will be relative to the existing value.

Example: :BRIG R10 will increase brightness with 10 steps

A Request acknowledges. This modiﬁer is only used to read back

the result of the command.

Default all commands send acknowledges so this will not be

necessary.

Default all commands send acknowledges so this will not be

necessary.

? Get current value

?M Get maximum value

?N Get minimum value

?D Get default value

?S Get default step value

1 2 3 4 5 6 7 8 9 10 ... 21 22

Komentarze do niniejszej Instrukcji

Brak uwag

Barco FS35 Instrukcja Użytkownika Strona 5

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Projektory Barco FS35