Barco R 9849999 Instrukcja Użytkownika

R 9849999 INSTALLATION MANUAL Ceiling Mount for CLM series projector Date 26/11/07 Rev: 00 Art. No.: R 59770182

Adjustments Following adjustment can be done in random order. Shift parallel to screen 1. Shift parallel to the screen Loosen the 2 bol

F vertical axis ±5°E Rotate aroundRotate around centralAxis ±3° G F

3. Rotate around central Vertical axis Loosen the 4 bolts E . Rotate/adjust the projector clockwise or anti clockwise. Tighten the 4 bolts E to secu

Mounting the bar with Cable Cover assembly 1. Unscrew the 2 bolts J and slide out the upper part of the Bar. Pass the cable cover into the upper pa

4. Routing the Cables a. RGBHV cable preparation: With the help of PVC tape arrange the connectors in series. Pass the Signal cables and Power cor

c. Pass the Power cord and the other cables (if any) one by one. d

6. Hang on the IQ bar and cable routed assembly. Fix with 4 M8 bolt along with washer M. M

There is also an option to route the cable from inside the Ceiling mount using cable ties and guiding holes on the Ceiling mount base as shown below.

9. The adjustment procedure for the rotation around central vertical axis can also be done as explained below. Loosen the 4 M3 screws N of cable co

Due to constant research, the information in this manual is subject to change without notice. Produced by BARCO NV,Nov.

Safety guidelines WHO WARNING CAUTION PRODUCT CARE This installation manual must be performed by authorized technic

Description and Contents of the kit Purpose of the Kit The kit is designed for the CLM CM R10 series projectors and allows the projector to be moun

Remark: The ceiling mount can also be mounted using one of the 2 available bars (height adjustment) and cable cover assy. R9841260: short bar R82292

Mounting the Assembly Necessary Tools 1. Torx screw driver for M3 screw 2. Hexagonal driver (n° 6) 3. Ring spanner 12-13mm 4. Side spanner

Mounting the Assembly The fixation can be done with standard M8 bolt (not supplied)

Projector preparation 1. Turn the projector to its back and remove the Feet assembly. Unscrew 3 Plastic feet and remove their Allen head M10 screws.

3. Lift and slide the projector assembly into the Ceiling mount. The projector will be located precisely into the ceiling mount base plate after the